Philips AVENT SCD535/00 Manuel d'utilisateur télécharger pdf (Page 19)



- Do not throw away the appliance with the normal household waste at the end of its life, but

hand it in at an ofcial collection point for recycling. By doing this, you help to preserve the

environment (Fig. 35).

- Non-rechargeable batteries and battery packs contain substances that may pollute the

environment. Do not throw away non-rechargeable batteries and battery packs with the normal

household waste, but hand them in at an ofcial collection point. Always remove non-

rechargeable batteries and battery packs before you discard and hand in the appliance at an

ofcial collection point. (Fig. 36)



If you need service or information or if you have a problem, please visit the Philips AVENT website

at www.philips.com/welcome or contact the Philips Consumer Care Centre in your country (you

nd its phone number in the worldwide guarantee leaet). If there is no Consumer Care Centre in

your country, go to your local Philips dealer.

Frequently asked questions

This chapter lists the questions most frequently asked about the appliance. If you cannot nd the

answer to your question, contact the Consumer Care Centre in your country.

Question Answer

What is ECO mode?

How does this

mode help the

environment?

The ECO mode has been developed to enable you to reduce your

energy consumption. Monitoring your baby from a small distance

requires less power than monitoring your baby from a large distance.

When you monitor your baby from a small distance, you can activate

the ECO mode. By switching on the ECO mode, your baby monitor

uses less energy and is therefore more enviornment-friendly.

Why don’t the

power-on light of the

baby unit and the LINK

light of the parent unit

come on when I press

the on/off buttons of

the units?

Perhaps the rechargeable battery pack of the parent unit is empty and

the parent unit is not in the plugged-in charger. Insert the small

appliance plug into the charger, put the adapter of the charger in a wall

socket and place the parent unit in the charger. Then press the on/off

button to establish connection with the baby unit.

Perhaps the non-rechargeable batteries of the baby unit are empty and

the baby unit is not connected to the mains. Replace the non-

rechargeable batteries or connect the baby unit to the mains. Then

press the on/off button to establish connection with the parent unit.

If the LINK light on the parent unit still does not start to ash, use the

reset function to reset the units to their default settings.

Why does the LINK

light on the parent unit

light up red

continuously and why is

the message ‘Searching’

shown on the display?

The baby unit and the parent unit are out of range of each other. Move

the parent unit closer to the baby unit.

The baby unit may be switched off. Switch on the baby unit.

ENGLISH 19

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 291 292

Commentaires sur ces manuels

Pas de commentaire

Philips AVENT SCD535/00 Manuel d'utilisateur Page 19

Commentaires sur ces manuels

Produits connexes et manuels pour Babyphones Philips AVENT SCD535/00